ASTM D6296 Standard Test Method for Total Olefins in Spark-ignition Engine Fuels by Multidimensional Gas Chromatography
ASTM D6296用多維氣相色譜法測定火花點火發(fā)動機(jī)燃料中烯烴總含量標(biāo)準(zhǔn)試驗方法
The quantitative determination of olefins in spark-ignition engine fuels is required to comply with government regulations.
Knowledge of the total olefin content provides a means to monitor the efficiency of catalytic cracking processes.
This test method provides better precision for olefin content than Test Method D 1319. It also provides data in a much shorter time, approximately 20 min following calibration, and maximizes automation to reduce operator labor.
This test method is not applicable to M85 or E85 fuels, which contain 85 % methanol and ethanol, respectively.
1. Scope
1.1 This test method provides for the quantitative determination of total olefins in the C4 to C10 range in spark-ignition engine fuels or related hydrocarbon streams, such as naphthas and cracked naphthas. Olefin concentrations in the range from 0.2 to 5.0 liquid-volume % or mass %, or both, can be determined directly on the as-received sample whereas olefins in samples containing higher concentrations are determined after appropriate sample dilution prior to analysis.
1.2 This test method is applicable to samples containing alcohols and ethers; however, samples containing greater than 15 % alcohol must be diluted. Samples containing greater than 5.0 % ether must also be diluted to the 5.0 % or less level, prior to analysis. When ethyl-tert-butylether is present, only olefins in the C4 to C9 range can be determined.
1.3 This test method can not be used to determine individual olefin components.
1.4 This test method can not be used to determine olefins having higher carbon numbers than C10.
Note 1—Precision was determined only on samples containing MTBE and ethanol.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately)
ASTM Standards
D1319 Test Method for Hydrocarbon Types in Liquid Petroleum Products by Fluorescent Indicator Adsorption
D4052 Test Method for Density and Relative Density of Liquids by Digital Density Meter
D4307 Practice for Preparation of Liquid Blends for Use as Analytical Standards
D4815 Test Method for Determination of MTBE, ETBE, TAME, DIPE, tertiary-Amyl Alcohol and C1 to C4 Alcohols in Gasoline by Gas Chromatography
D5599 Test Method for Determination of Oxygenates in Gasoline by Gas Chromatography and Oxygen Selective Flame Ionization Detection
D4052 Test Method for Density and Relative Density of Liquids by Digital Density Meter
D4307 Practice for Preparation of Liquid Blends for Use as Analytical Standards
D4815 Test Method for Determination of MTBE, ETBE, TAME, DIPE, tertiary-Amyl Alcohol and C1 to C4 Alcohols in Gasoline by Gas Chromatography
D5599 Test Method for Determination of Oxygenates in Gasoline by Gas Chromatography and Oxygen Selective Flame Ionization Detection
Index Terms
gas chromatography; gasoline; multidimensional gas chromatography; olefins; spark-ignition engine fuels; Automotive engine fuels/oils; Gas chromatography (GC)--petroleum products; Multi-dimensional gas chromatography; Olefins content; Total olefins
