ISO 178塑料 彎曲性能測定—標準名稱

ISO 178 Plastics - Determination of flexural properties

ISO 178塑料 彎曲性能測定

ISO 178塑料 彎曲性能測定—適用范圍

Scope：

This document specifies a method for determining the flexural properties of rigid and semi-rigid plastics under defined conditions. A preferred test specimen is defined, but parameters are included for alternative specimen sizes for use where appropriate. A range of test speeds is included. The method is used to investigate the flexural behaviour of the test specimens and to determine the flexural strength, flexural modulus and other aspects of the flexural stress/strain relationship under the conditions defined. It applies to a freely supported beam, loaded at midspan (three-point loading test).

ISO 178塑料 彎曲性能測定—引用文件

ISO 291, Plastics — Standard atmospheres for conditioning and testing

ISO 293, Plastics — Compression moulding of test specimens of thermoplastic materials

ISO 294-1:2017, Plastics — Injection moulding of test specimens of thermoplastic materials — Part 1: General principles, and moulding of multipurpose and bar test specimens

ISO 295, Plastics — Compression moulding of test specimens of thermosetting materials

ISO 2602, Statistical interpretation of test results-Estimation of the mean-Confidence interval

ISO 2818, Plastics — Preparation of test specimens by machining

ISO 7500-1, Metallic materials-Calibration and verification of static uniaxial testing machines-Part 1:Tension/compression testing machines — Calibration and verification of the force-measuring system

ISO 9513, Metallic materials-Calibration of extensometer systems used in uniaxial testing

ISO 10724-1, Plastics — Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) — Part 1: General principles and moulding of multipurpose test specimens

ISO 16012, Plastics — Determination of linear dimensions of test specimens

ISO 20753, Plastics — Test specimens