ISO 62塑料.吸水性的測定—標準名稱

ISO 62 Plastics - Determination of water absorption
ISO 62塑料.吸水性的測定

ISO 62塑料.吸水性的測定—適用范圍

Scope：

This International Standard describes a procedure for determining the moisture absorption properties in the “through-the-thickness” direction of flat or curved-form solid plastics. This International Standard also describes procedures for determining the amount of water absorbed by plastic specimens of defined dimensions, when immersed in water or when subjected to humid air under controlled conditions. The “through-the-thickness” moisture diffusion coefficient can be determined for single-phase material by assuming Fickian diffusion behaviour with constant moisture absorption properties through the thickness of the test specimen. This model is valid for homogeneous materials and for reinforced polymer-matrix composites tested below their glass transition temperature. However, some two-phase matrices such as hardened epoxies may require a multi-phase absorption model which is not covered by this International Standard.

ISO 62塑料.吸水性的測定—引用文件

ISO 175 Plastics — Methods of test for the determination of the effects of immersion in liquid chemicals

ISO 294-3, Plastics — Injection moulding of test specimens of thermoplastic materials — Part 3: Small plates

ISO 2818, Plastics — Preparation of test specimens by machining

ISO 62塑料.吸水性的測定—相關標準

ASTM D570塑料吸水率的試驗方法-國家標準網/Standard Test Method for Water Absorption of Plastics

ASTM D229電絕緣用硬質薄板及板材的標準試驗方法/Standard Test Methods for Rigid Sheet and Plate Materials Used for Electrical Insulation

ASTM D349電絕緣用層壓圓棒的標準試驗方法/Standard Test Methods for Laminated Round Rods Used for Electrical Insulation

ASTM D348電絕緣用剛性管的標準試驗方法/Standard Test Methods for Rigid Tubes Used for Electrical Insulation

ISO 62塑料.吸水性的測定/Plastics - Determination of water absorption

GB/T 1034塑料 吸水性的測定/ Plastics - Determination of water absorption

IS K7209塑料.吸水率的測定/Plastics -- Determination of water absorption

GB/T 23641 電氣用纖維增強不飽和聚酯模塑料/ Fiber reinforced unsaturated polyester moulding compounds (SMC and BMC) for electrical purposes

ASTM D570塑料吸水率的試驗方法-國家標準網/Standard Test Method for Water Absorption of Plastics